must transfer your original home button to the new display assembly. Slide a battery isolation pick underneath the battery connector area of the logic board, and leave it in place while you work. If you want to maintain functionality you will need to transfer the component. Edit Use the flat end of a spudger to peel up the Home Button ribbon cable and Touch ID control chip. Edit Bring the right-hand opening pick around the bottom corner of the iPad. Introduction, follow this guide to replace a broken front panel assembly on an iPad Air 2 Wi-Fi. Edit Slide the opposite opening pick down to the bottom right corner of the iPad. Edit Slide the left-hand opening pick along the bottom edge of the display, then remove it from the bottom right corner of the iPad. If there is still a considerable amount of resistance when sliding the opening pick, repeat the iOpener heating procedure and apply additional heat. Edit Firmly pull up on the suction cup to to create a small gap between the front panel and the rear case.
Ipad air 2 screen replacement eBay
Anwb lidmaatschap korting autohuur
Deliveroo korting amsterdam
Cjp korting zilveren kruis
Stone island korting
Handling it by the tabs on either end, place a heated iOpener over the top edge of the iPad. A good rule of thumb is to never insert the opening pick more than a quarter inch (6 mm) into the iPad. Throughout the repair procedure, as the iOpener cools, reheat it in the microwave for an additional thirty seconds at a time. Keep lifting until the display assembly is roughly perpendicular to the body of the iPad. Edit Insert a third kortingscode sushi by me pick by the front-facing camera.